Trike clutch cable adaptor: Modern cable on ‘76 sportster motor, part 2
With the end for the new clutch cable made, now I just had to make the adaptor. I used a section of the old cable with the cable stop installed. I drilled an 1/8″ hole in another pipe plug, threaded the cable through and measured it for length.
Then I silver soldered the pipe plug to the cable. Some flux and a propane torch was all that was needed.
Here’s completed assembly using an 1/8″ coupling to connect the two cables.
Now I just need to make a pin for the clutch handle to finish it off.
